Before running the Spindle & Spindleless veneer peeling machine, the operators should check the appropriate install location of main parts and machine situation. The operator should learn the structure and technical datasheet to avoid the mis-operation and exceed performance operation.Stopped immediately when some abnormal happen and start again after getting rid of the matters you can run it again. Periodic check the feeding stroke, clean and oil the machine to ensure working status.

Sanmu Sansen is a professional plywood machine production factory.We produce the whole set plywood machinery including veneer peeling machine, veneer dryer,glue spreader,plywood cold press machine,plywood hot press machine,plywood edge cutting machine,boiler and plywood sanding machine. In April, one line of 4ft Spindleless veneer peeling machines was shipped to Malaysia to peel acacia and other hard wood.

In Jan, we shipped some plywood making machines to Philippine. The following are the machines. 1. 20 Layers-600 ton Hot press machine for plywood 2. Plywood sanding machine 3. Wood veneer fiber tendering machine

There are two kinds of Wood veneer peeling lathe for veneer making, spindless and spindle. Let's learn the difference. The spindle veneer machine was originally used to peel big log, which diameter is usually more than 600mm. It uses chuck to grab two ends of the log and peel the veneer, especially face & back veneer for high-end plywood. The log processed should be bigger than the chuck diameter. After several years of cutting, there are fewer and fewer big diameter trees. More and more smaller logs ask people to invent another kind of veneer making machine. So people invent spindleless veneer peeling machine to process small logs to increase utilization rate, especially log small than 400mm.Spindleless veneer lathe also has the advantages of labor cost saving and easy operation.